I have the same thing on my door, its not real wood, so i used a little white glue and stuck it back down and the put clear laminate like stick on shelf liner on the corners.
__________________
2017, 3500 Ram Big Horn, 4x4, Crew Cab, DRW, Aisin Transmission, 4:10. Curt Q20, 2014 Mountaineer 331 RLT, Sailun's on the rv and truck.
I have the same thing on my door, its not real wood, so i used a little white glue and stuck it back down and the put clear laminate like stick on shelf liner on the corners.
took the words off my finger tips - good recommendation
__________________
RAM 22' DRW 3500 Crew LB 40 gal reserve tank / RETRAX Bed Cover / 2020 373RD HC / IS / MOPEKA Tank Monitor / Furrion Side&Rear Cameras
Slide Toppers / EMS-HW50C / Sailun 85's
3rd AC / Dometic 320
__________________
Bob & Carol Washington St
2017 HC HM352RL 2018 Dodge 3500 laramie CC LB 4x4
Curt Q25 with puck system, Factory air bags
Happy Trails
It happened on my bedroom door. I used contact cement. Stuck it back down.
__________________
MikenDebbie Aggie ‘77 in the sticks near Austin TX
2019 Chevy 3500 High Country DRW
2018 Montana 3921FB
Aussie Gus + Texas Heeler Jimmy
It doesn’t have the quality of my Bluebird Wanderlodge! But then it was a 1987 and cost $465,000 then! All steel and 13 ply wood and not a bit of press-wood or particle board. 38,000 lbs empty. It was the Marathon coach of it’s day! Sigh.....🤢
__________________
Jim and Barb
Chica and Baby (the fury kids)
2014 3402rl
2017 Ram 3500 6.7 ctd. 4x4 srw
Maybe we could grab some on the factory tour in SEPT.
I would like to retract my comment made in jest - this might be misunderstood and should never have been made. Maybe at best Montana could advise if there is a source where these door handles could be purchased by the public.
Thank you all for accepting my apology.
__________________
RAM 22' DRW 3500 Crew LB 40 gal reserve tank / RETRAX Bed Cover / 2020 373RD HC / IS / MOPEKA Tank Monitor / Furrion Side&Rear Cameras
Slide Toppers / EMS-HW50C / Sailun 85's
3rd AC / Dometic 320
__________________ I was once intelligent beyond my years.Now, I’m years beyond my intelligence. 2020 Montana 3561 Legacy, everything except paint. 2018 Silverado 3500 DRW, 50Gal Transfer Flow, Andersen hitch.
First door knob/handle I've seen like that in a Monty. Our 2018.5 3791RD has standard knobs.
My apologizes for not seeing all the suggestions, Thank You for those: we were moving storage again. By the by, I found these knobs back in 2011. (buyhampton.com). We had a knob that liked to grab our butts as we walked by, thus the knobs. There are so many advantages, we like them and immediately changed them out in our Monty.
Warning, working on the door to get them to fit must happen.
You have to gouge out the jam plate and recess it, the shaft has to be bored out to 1 inch and working with those paper doors, I had to be careful. It's not a speed project.
They came out OK. My old Everest had better doors I must say. The handles work on both sides of the door, push to go thru the door and pull to enter. Never use the locks now included in the purchase. Never knew or saw them on Home Depot or Amazon, just went thru their website.
Experienced the same problem with my 2019 3811MS. I have it at the dealer and all 3 doors are being replaced under warranty. I really expected better quality out of a Montana. Sorry the pictures are at 90 degrees to what they should be....not as tech savvy as some.
My other Keystone toy hauler I had the same problem. I went and pulled off the door. Went to a cabinet shop and got cabinet veneer that they use for refacing and there glue. Looks like a new door...
__________________
Charlie & Sofia
Sawyer (The Lawyer) Buster Brown Fur - babies
I think I would be able to do that!
Thanks for the suggestion.
Really disappointed this is happening after less than a year ownership though...
Bought brand new.
Experienced the same problem with my 2019 3811MS. I have it at the dealer and all 3 doors are being replaced under warranty. I really expected better quality out of a Montana. Sorry the pictures are at 90 degrees to what they should be....not as tech savvy as some.
I have the same 5er as you and have the same problem. I took it in under warranty after putting blue painters tape at each place that had pealing. After 3 months I got it back “finished “ LOL , several pieces of tape still on. Now a year later my door looks like your pictures. Out of warranty so will have to figure out myself. I’m very disappointed in Keystone quality.
I do like the idea of getting better quality veneer and just recovering the whole door.
On the bright side we do like the floor plan