|
01-26-2006, 03:25 AM
|
#1
|
Established Member
Join Date: Jul 2005
Location: Tucson
Posts: 17
M.O.C. #4155
|
propane gas lines
Every time we change/fill tanks we seem to have a problem with the line. It's like there's a blockage. We get just a tiny flame. Then, hours later, all is fine. We spoke with a repair person over the phone, he said "that's a problem with those Montana's". Don't know what he meant as he never showed up for the appointment. (We waited all day. We are staying at an RV resort for the winter and had phoned an rv repair person out of the yellow pages.)
Anyhow, we also have a problem with the fan in the kitchen ceiling. Sometimes it works and sometimes it doesn't.
We bought the Montana new in Mesa. The dealer has replaced the refrigerator and microwave (both went bad within a month of purchase) without a problem. Inspite of all, we love the 5th wheel.
When we had the Mountaineer we had no problems what-so-ever. Go figure.
Any suggestions or words of advice would be appreciated.
By the way, I love this web site.
|
|
|
01-26-2006, 03:45 AM
|
#2
|
Montana Master
Join Date: Jan 2005
Location: Cooper
Posts: 1,230
M.O.C. #3029
|
Karen-
This is not to say what I experienced is the same as your problem. After the first time the street side tank emptied the switching valve failed. I replaced it and the next time the street side tank was to switch, it again failed. While I went to get a new regulator for a second time thinking that it was some kind of coincidence to come across two bad regulators, when I got home I realized what the problem was. On the concrete slab under where I had left the hose hanging down there was about 1/2 teaspoon of oil on the ground.
Where did the oil come from was the next question? My guess is when the threads on the 3/4" crossover pipe were cut for some reason the pipe was not cleaned of thread cutting oil and this migrates into the regulator and switching valve each time I used propane from the street side. As of now I only use propane from the curb side and will have the situation resolved next time I have it back to the dealer. He has been informed of the problem and will look at it.
If you are getting some type of residue as I have, it could be causing your problem until it pushes through and then clears up.
|
|
|
01-26-2006, 11:51 AM
|
#3
|
Established Member
Join Date: Dec 2005
Location: Clarkston
Posts: 30
M.O.C. #5036
|
You may want to have the propane lines checked out. The Cougar we had just before we got our Monty had furnace problems and one of the things they found was that a gas line had been twisted almost shut when the factory tightened the fittings.
|
|
|
01-26-2006, 01:21 PM
|
#4
|
Montana Master
Join Date: Jun 2004
Location: San Antonio
Posts: 1,740
M.O.C. #1757
|
Karen, welcome and I'm glad you like this web site. There is so much to learn. Without this site life would be difficult.
|
|
|
01-26-2006, 02:09 PM
|
#5
|
Montana Master
Join Date: Nov 2005
Location: cedar rapids
Posts: 703
M.O.C. #4962
|
When you open the tank valve be sure that you open SLOOOWLY. If you open it fast the gas will come out very slow. That is why everyone had to change to the new valves. If there is to much flow all at once the valve goes into a mode so as the gas will come slowly. Maybe you are opening it to fast.
|
|
|
01-27-2006, 02:46 PM
|
#6
|
Established Member
Join Date: Feb 2005
Location: Rigby
Posts: 35
M.O.C. #3071
|
I had the same problem the service manager at my dealer told me to try opening the valve slowly. The new OPD valves are set up with a type of check valve that stops the flow if a line should break. The pipe run from the street side takes a few seconds to fill so if you turn the valve on to fast it is like a ruptured line and shuts down fuel flow.
I hope this makes sense.
|
|
|
01-27-2006, 04:29 PM
|
#7
|
Montana Fan
Join Date: Feb 2005
Location: Moultonborough
Posts: 449
M.O.C. #3268
|
Simulia to the other two post.
The other thing with the new valves is that if you do not tighten the fitting into the valve real tight, the valve will not open or open all the way.
So make sure that your fitting on the tank are tight
|
|
|
01-27-2006, 05:12 PM
|
#8
|
Montana Master
Join Date: Dec 2004
Location: Morgan City
Posts: 642
M.O.C. #2773
|
Welcome aboard Karen, Good answers people
|
|
|
01-30-2006, 10:40 AM
|
#9
|
Montana Master
Join Date: Nov 2002
Location: Oceanside
Posts: 20,028
M.O.C. #20
|
Just a tip -- our bbq grill runs off the Montana's propane tank. The regulator died last week and spewed forth enough gas to cause the propane valve to stop the flow. It stopped it completely. On a whim I took the tank out and turned it upside down a couple of times then let it sit upside down for about 30 seconds, hooked it back up and slowly opened the valve. I had propane again! I don't know if this is the prescribed procedure but it worked. This time anyhow.
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
Similar Threads
|
Thread |
Thread Starter |
Forum |
Replies |
Last Post |
Damaged pex lines
|
JandC |
General Discussions about our Montanas |
6 |
04-15-2014 10:41 AM |
water lines
|
tom41 |
Montana Problems, Problem Solving & Technical Help |
4 |
01-18-2009 03:03 AM |
SAD SAD SAD, gas lines
|
Mrs. CountryGuy |
Sitting around the Campfire |
11 |
09-24-2008 05:51 AM |
Twenty Nine Lines
|
DHenry |
Sitting around the Campfire |
5 |
11-14-2007 04:28 PM |
Water lines
|
Montana_24 |
General Discussions about our Montanas |
0 |
09-14-2003 02:44 PM |
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|