In.Command

[jstadler]

Has anyone had an In.Command on a 2017 Montana that would permit the hydraulic slides to go out but not to come in? The pump and hydraulic system is working fine but the In.Command will not permit retracing the slide outs. They will come in for 3 seconds, then 2 seconds and stop. Then they will do the same over.

New board, so odd what could be controlling the inbound? Not a breaker or a solenoid on the board.

Thanks

[Bridge4d]

That behavior actually sounds like the breaker in the battery compartment. It's a 50amp breaker located between your battery and the hydraulic pump. Replace it with an 80 amp breaker.
https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1

[Carl n Susan]

Have someone stick their head in the front compartment near the breaker while you operate the slides. You can hear the breaker click when it overloads. If you want to be double sure, jumper over the breaker and see if the slides work like they should.

[jstadler]

We took the wire to close the slide outs and placed it on the side that opens the slide out and it worked. The in.command saw this as opening but the circuit to close was working fine we also checked the breaker it seems fine. Any other suggestions? This all worked fine until the dealer replaced the BMC. Now it's a mess.