 |
05-14-2024, 10:09 PM
|
#1
|
|
Montana Master
Join Date: Dec 2010
Location: Anytown
Posts: 621
M.O.C. #10966
|
Rear 15k A/C not blowing cold air
OK, I've given up searching for this topic, but I'm sure it's been addressed before...so if someone can provide a link to the thread, I would appreciate it!
I've added a Micro Air Soft Start unit and cleaned the coils and fan, but the unit still blows just slightly cool air (VERY slight). Not even close to cold air...plus it cycles on and off continously. Runs for 3 minutes, shuts down and then restarts a few minutes later.
Can these units be recharged with new refrigerant? Or should I look at just upgrading/replacing it?
Thanks for any feedback or experiences with this!
__________________
2011 Montana 3580RL, Reese 20k GooseBox w/offset B&W ball, Sailuns, RoadMaster shocks, Splendide stacked washer/dryer, Progressive HW50C, some other stuff...
2015 Ram 3500 DRW Laramie Megacab, Aisin w/3.73s, 255/80 17 Toyos A/T III, rear auto level, 40 gal. fuel/tool combo box, B&W Turnover ball,
|
|
|
|
05-15-2024, 01:58 AM
|
#2
|
|
New Member
Join Date: May 2018
Location: Austin
Posts: 5
M.O.C. #21872
|
I had the same problem with my Dometic 15K. I have a Micro Air Easy Touch thermostat. The Easy Touch has an information button which shows the coil temperature. I was able to watch the freeze sensor reading bouncing down to as low as -17 degrees, which would cause the AC to cycle off. A few minutes later the reading would change to 60+ degrees and the AC would cycle back on. I replaced the freeze sensor and that solved the problem because it provides an accurate reading of the coil temperature.
https://a.co/d/cUmeIXW
|
|
|
|
|
05-15-2024, 09:03 AM
|
#3
|
|
Montana Master
Join Date: May 2019
Location: Alton
Posts: 2,933
M.O.C. #24086
|
The freon system is sealed. There are no ports to recharge it.
I have read of someone getting a HVAC guy to install a saddle Tap and recharge the system.
__________________
Daryl and Marianne,
2019 3130re 20th Anniversary Edition
2016 F350 Lariat
|
|
|
|
|
05-15-2024, 10:45 AM
|
#4
|
|
Montana Master
Join Date: Oct 2014
Location: Hagerstown
Posts: 914
M.O.C. #16013
|
Quote:
Originally Posted by Daryles
The freon system is sealed. There are no ports to recharge it.
I have read of someone getting a HVAC guy to install a saddle Tap and recharge the system.
|
Saddle valves are cheap and easy to install. Buy a can of freon and put some in if it gets colder buy a cheap set of gauges from HF to top it off to the correct pressure. (easy enough to find on the Net and You Tube). Just remember if you need freon you have a leak because these are closed systems. Need to address the leak first. I had the same problem gauged in freon it would cool for about a week then had to put more in it would last a week, never did find the leak, gave up took the unit off and tossed it off the roof and put a vent in it`s place. Then I installed an 18,000 btu Mini Split system, what a difference.....never going back to those noise makers.
__________________
2018.5 3791 Rear Den Montana, on the lake  no 3rd A/C, Mini Split
Electric Brakes  ..... Disk Brakes, it`s the only way
F350 Ford Dually 4:10`s w/bags (payload 5595 lbs) Sumo Springs 63 gal aux tank
Reese Goosebox Mor/Ryde SRE 4000 X Factors Monroe shocks.... real smooth ride
|
|
|
|
|
05-15-2024, 12:20 PM
|
#5
|
|
Montana Fan
Join Date: Feb 2022
Location: Cynthiana
Posts: 327
M.O.C. #30449
|
Are you certain that the compressor and blower are both coming on? If just the blower is starting, the air might feel slightly cool just from the air movement. Double check your wiring and there's always a possibility that the new soft start is defective. This doesn't explain the cycling on and off.
|
|
|
|
|
05-15-2024, 01:41 PM
|
#6
|
|
Montana Fan
Join Date: Jan 2023
Location: Orange County, CA
Posts: 243
M.O.C. #32230
|
Ditto on checking wiring (esp if you had to crimp any connectors) if your AC was working before soft start install. You could try uninstalling too.
I suppose it’s possible a new problem has come up but would be good to double check the install and rule out the soft start first - if the AC was working prior.
We have a different brand soft start - there was a green light that came on to let you know it was hooked-up correctly. I also remember there were a couple of lines in the instructions that I had to reread a few times for the control board and one of the compressor wires.
|
|
|
|
|
05-17-2024, 10:32 PM
|
#7
|
|
Montana Master
Join Date: Dec 2010
Location: Anytown
Posts: 621
M.O.C. #10966
|
Great info guys...thanks for the ideas!
I am sure the Micro Air SoftStarts are working fine...forgot to mention that the A/C hasn't been blowing cold for a long time.
I've just been living with it, but I'm getting tired of dealing with the poor performance and am determined to figure out a solution.
I had also installed a Micro Air Easy Touch RV thermostat earlier this year...Which just went "belly up" on this trip a few days ago!! The screen display is crazy...upside down display with random numbers and info... 
Fortunately, I have the Micro Air app which I can control the system with regardless of what the display is showing. Frustrating? Yep...
Got some work to do when I get home...  Along with the usual repairs, tweaks, upgrades etc.
Gotta reach out to Micro Air for a new thermostat...this one looks like a bad board or something. Clearly defective.
Strongly considering upgrading both A/C units to a lower profile unit, possibly with heat pump? Lots of research to do...
Appreciate the feedback!
__________________
2011 Montana 3580RL, Reese 20k GooseBox w/offset B&W ball, Sailuns, RoadMaster shocks, Splendide stacked washer/dryer, Progressive HW50C, some other stuff...
2015 Ram 3500 DRW Laramie Megacab, Aisin w/3.73s, 255/80 17 Toyos A/T III, rear auto level, 40 gal. fuel/tool combo box, B&W Turnover ball,
|
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Linear Mode
