|
Chuck,
I have just today pulled the spare off the rear of the rig and I am going to re arrange the hoist setup on it as it came from the factory it hung down 14" from the bottom of the rig, and the wheel/tire is 9 1/2 wide so with a little re engineering I can gain
a little right off the git go. and I believe I will move it fwd and
gain some there also. if it falls, which it should not as I am using heavier material than stock, it will be in between the wheels, so they should not be affected. By the way, did you know the stock setup is held up by four 1/4x20 bolts and four 1/4" sheet metal screws?
Thanks for everyones help. Again great resource
Dee
|