Quote:
Originally Posted by Mic_
Thinking about the going the UHMW ski route.
should teh ski be long enough to always be on the wear bar (i.e. when fully extended the the ski is still riding on the wear bar)
This mean I jack up teh slide a bit to get it in far enough to remain on the ski.
rather than 'falling off' the wear bar as the slide hits full extension out?
thought?
|
My dining slide (the one that ramps up as it starts in) skis do not always sit on the wear bar. I used the bevel method. So far (1.5 years), so good.
My kitchen slide (does not move up as it starts in) always sits on the skis as you describe. At first, I tried to do it the same as the dining slide; first time retracted they ripped off because the kitchen slide does not move up.
__________________
Scott & Alta
2017 Montana 3160RL, Legacy, Onan 5.5Kw, Solar
2022 F-450 Lariat Ultimate