[scottkeen]

I have a 2011 Montana Mountaineer 347THT

I don't understand how the cable TV and roof-mount antenna are wired and how I'm supposed to connect them to the TVs.

In the Living Room, behind the TV are (3) coax connectors on (2) wall plates. (1) coax connector is on the top wall plate by itself and has a black cable. The other (2) coax connectors are on the bottom wall plate below and both have orange cables.

In the Bedroom, in the W/D closet there is a wall plate labeled "Winegard" with a 12VDC power outlet, a pushbutton that says "On" "Off" with an LED that lights up when the pushbutton is pressed to On, and a coax connector. Behind the wallplate are (3) coax cables -- orange, black, gray. Above the bed is a hand-crank to raise and lower the antenna and a dial to spin it around.

In the Garage, there is a wall plate with (1) coax connector with a black cable.

In the Camping Side Pass-Thru Storage, there is a wall plate with (1) coax connector for outside TV viewing with a black cable. I'm not trying to use this.

In the Wet Bay of the Hookup Side Pass-Thru Storage, there's a cable TV coax connector with an orange cable labeled "Cable/Satellite". I believe this is how you connect to the campground cable TV source on the pedestal.

I don't understand how this is all wired and how to get cable TV or antenna TV to the Living Room TV and Bedroom TV.

Can someone please explain this, and how to properly connect the TVs in the Living Room and Bedroom?