|
Removing the Tank... 1. Remove the screws that hold the carpeted panel in place then slide the panel out of the way to access the pipes.. Drain and Vent.... 2. Cut pipes with sawzall or a hand saw.. 3.0 Remove the bottom to gain access the to tank. There are many Steel Nails that can be removed with pliars or a swazall again.. Replace with self tapping screws and washers.. 4. Disconnect the blade valve near the tank, cut the wires or remove wire nuts. These are for the Heater blanket and the level sensors. Unscrew flush out hose from tank.. 5. Loose the 4 7/16s boltsl hold one rail to the tank and slide it away from the tank.. Tank is light and will come down.. 6. Repair or Replace the tank.. When reinstalling the Vent and Drain pipe on top i used rubber boots and clamps so I would be able to remove in future... A new tank is 400 to 500.. However, the Drain and vent pipes must be reinstalled in the new tank.. Use a cloth or screen and ABS cement to repair... Above all.. Have Fun!!
|