slide right
OK, I finally got back under the slide. Rather then messing with the gears directly, I took a different route. I removed the bolt that connects the square tubing that brings the sides out the same amount at the same time, from the rod that connects it to the gear shaft. I then I had my wife sloowly bring the slide in. With only one side of the slide moving I was able to measure both sides and stop when they were evenly space. I then replaced the bolt. (with my wife nudging the slide until the holes lined up) I'm glad to say the slide now has the same amount on both sides. WHEW!! It slides RIGHT!
Thanks to all for the info and encouragement.
Ed
|