Mor/ryde rubber update...
After some failed attempts to get picts through Mor/ryde's email filters, I finally got them to Chris Elledge of Mor/ryde. He has set up an appointment for me at Josam Frame and Alignment of Orlando. It is only about 20 miles from me and I should not have any problem getting it there this coming Tues (22nd).
Mor/ryde is shipping the part for free right to the repair shop, who will send the bill directly to Mor/ryde for the repairs. Apparently this is only supposed to take about 1 1/2 hrs.
It is called a "bond failure" by Chris. He says it happens in about 1 out of every 500 assemblies. He did give a little pause as he gave me that figure over the phone, so that may not be an "official" statistic - just a rough estimate on his part.
I will keep everyone posted...
|