Hi Jim,
Been there. First remove rear wheels and re-install 180 degrees out. The holes in the Alcoa are too small for both stems.
While the wheels are off, remove the plastic extender on the inside steel and cap off the outside Alcoa wheel. Install a fill thru cap. Any large truck tire shop will probably either have them in the shop or under the counter. They look like this.
http://www.alcoa.com/alcoawheels/nor..._valve_cap.asp
The straight on air gauge will do the inside and the angle will fit the Alcoa wheels. I put caps on all 6 stems.
http://www.amazon.com/Milton-S986-Se...keywords=truck
Might look at this thread
http://www.montanaowners.com/forums/...ad.php?t=56259
Jim
__________________
2012 Ram Laramie 3500 DRW 4x4 3.73 Tow Max Pkg B&W Companion 60 gal RDS aux fuel tank. 2014 Montana 3150RL, 2 A/C's, Leather, 6 Point Jacks, Splendede WD2100XC, Mor/ryde X-Factor, Duravis 250 tires with TST 507RV monitors. 2 x Honda EU2000's