[rohrmann]

I didn't do the work, but CW in Las Vegas did over six years ago. They ran the power/control cable across the roof all the way to the front and down into the closet where they placed the satellite dish control box. The two coax cables were run to a point above the area where the converter/electric panel is located, and there is where they found the coax that was factory installed to bring the OTA antenna signal from that front closet back to the living room TV. They cut the coax, put connectors on both ends and tied one cable from the dish to the front coax and the other to the living room coax. Made for a very clean installation.

This is a photo of the area behind our electric panel, and the two orange coax cables were the one cable that went to the living room TV, and were cut. The two coax cables next to each other, one gray and the other black, are the two cables from the Travler dish and one was connected to the rear and the other to the front orange coax cables. Hope this helps.