|
Thank you for replying ,
There is 2 50amp breakers located on the wall behind the batteries.
I checked both terminals on the breakers as I was putting the slide outs in and when they stopped I still had 13volts coming out of both breakers. I then checked for voltage on the wires going to the solenoid and when the slides stop i lose power to them. I pulled the cover off the in command brain and it seems I lose power to the wires coming out of the brain going to the solenoid. It even temporarily shuts down my Bluetooth connection to my control panel for the in command when the slides stop. I'm not sure if there is another breaker or if my in command brain is the issue. It usually takes about 15 sec before I can begin to move the slides again.
|