|
Something like lugnuts is tied to safety and not something I know enough about that I could be comfortable saying go ahead. However, besides length are there any other differences? Do they have the same bevel angle as the originals? Do you have the aluminum rims and, if so, will these clear the rim holes (ours are pretty deep) enough you can seat a wrench to properly torque/install/remove the nuts? Since you said they fit fine I assume the thread matches. And by not bottoming out I assume you mean they'll fully seat and tighten without the lug hitting the end of the nut.
If all of that is true then I'd be tempted to try them but I might try two per wheel for awhile and check to make sure the torque holds after going through the retorquing period.
|