View Single Post
Old 02-19-2020, 03:30 PM   #19
Razahoryin
Seasoned Camper
 
Join Date: Aug 2016
Location: Tustin Calif
Posts: 73
M.O.C. #18958
Ok so my 2007 3000RK
Remove the closeout panel that shields/hides the water pump/furnace and converter...
It’s on the passenger side aft basement wall
Made of the same type of press board that’s in the rig..

The converter/battery charger /furnace and water pump is in this same area that you can access from the basement.. you can either tap into that existing converter circuit or add a dedicated circuit with breaker..

To add a dedicated Romex circuit
Remover ac power and then remove or loosen the ac circuit panel that is mid coach near the entry door
There should be a opening behind the panel leading to the basement.. that will allow for the new wire or circuit...it may help to trace the converter wire
Then decide if you need to add a hole for new wire
New hole should not be necessary
Feed your new circuit from behind panel to the basement// back side of furnace
You should have a few open breaker slots to add a new breaker to the panel.. mount a outlet box in the basement and you should be good to go
Razahoryin is offline   Reply With Quote