[Theunz]

Don’t leave now Dieselguy it’s just getting �� The axles are about 7 feet long and have fairly thin walls. It doesn’t take much to deflect one end of an seven foot tube. I have seen 40 foot by 12 foot 4 inch steel plate bend like a banana when picked up in the middle. Sure it will lay back flat when you set it down, just like the axle will when you take the tension off the end. Now to put a permanent bend in the axle like the alignment shops do, does indeed take a lot of pressure. I’m not saying that correct track is the greatest thing since pockets on shirts, but I do believe that it will correct SOME slight alignment problems.