Thread: Low heat output
View Single Post
Old 04-03-2006, 02:14 PM   #8
sgf
Montana Fan
 
Join Date: Nov 2003
Location: williamsport
Posts: 252
M.O.C. #680
The dealer is correct ,one 90 degree bend is the same as adding 6 extra feet of pipe to that run.Also check that the silver tape around the grilles has not come loose under the grille. This will also block air flow. I removed all the cheap flex duct and installed hard pipe in as short a run as possible. Made a good bit of difference and doesnt rip like the old did in the storage area.
sgf is offline   Reply With Quote