Quote:
Originally Posted by rickg
Installed new dexter brakes on my 2010 montana 5th. Hooked up to road test wouldn't stop my truck at idle. Check if magnets engage,which they do. Tried again after checking the brake shoe adjustment, still no stopping the truck.
Checked tha factory Ford brake control, full voltage at the female plug. Engaged the controller @full setting(10), went under to check voltage to the brakes. Reading was @ 11.5 volts. Then I installed new cord from rv to truck,as the plug had the wonderful green color to them. After the change out, still at 11 volts, no power to stop
The truck.
I'm at a loss. Please, anyone who has ever run into this, please help.
Thank rick
|
#1, how did you verify that the magnets “engaged”?
#2, exactly where/how did you check the voltage to the brakes?