|
If these are all hydraulic then the motion sequence is..
1. Smallest slide will always open or close first ( usually the BR )
2. The two large slides will begin to move with the slide closest to the hydraulic
pimp fully closing first followed by the last slide that is farthest from the hydraulic pump
There is also an IRC ( individual room control ) that has a valve for each hydraulic slide that can be closed so that the slide will not move..
Also if this Montana never had the OEM 50 amp resettable breaker that runs from the battery area up to the dual polarity solenoid replaced this can open up and cause the slides to stop motion till breaker resets itself then move some more then trip again..
An 80 amp resettable breaker solves this issue
|