Quote:
Originally Posted by sourdough
Every transport system for a slide has its own operating parameters - and problems. A hydraulic slide does not operate like a cable slide so they aren't really comparable. The degree that a slide runs on a wear bar depends on the type of system, adjustment etc. A cable slide "does" depend on the darco running over the wear bar...it just does per BAL.
If you don't have issues with darco count yourself as a lucky person. As one of those that has had multiple problems with it and dealt with it....
|
Apparently now I have a slide issue. I have noticed of late the fridge side of the kitchen slide has been putting a mark on the floor. I looked under there today and apparently the wear bar stops short of the edge of the slide by about 2 and 1/2 in and it's digging into the underside of the slide floor.
Don't know if that we're bar was short like that from the factory. I'm going to attempt to adjust the slide upward so that it doesn't ride on the wear bar as much