View Single Post
Old 10-17-2020, 08:24 AM   #3
daveinaz
Montana Fan
 
daveinaz's Avatar
 
Join Date: Jan 2019
Location: Sun City
Posts: 408
M.O.C. #23256
I pulled all the carpet from our Montana yesterday - main floor and slides. (I’ve yet to put the carpet from the bedroom/bath upstairs) I’m going to put a sheet of 5mm plywood on the slide floor to bring the vinyl plank up to near the top of the plastic runner on the slide. It will leave about 1/2” of the runner showing but that’s okay with me.

The thing I’m trying to figure out is how to cover the heads of the carriage bolts and the 1/4” rise from the main floor next to the slide out. I may just run the plank flooring up to the bolt heads and then glue down a piece of trim or transition to cover them and little strip of plywood next the runner. Or add a one inch strip of 1/4” plywood along the main floor edge where it meets the slide out runner. I could cut the underside of the plywood where it goes over the carriage bolt heads, and then glue down either transition or flooring over it.
__________________

Dave in AZ
2008 Montana 3400RL
2008 Dodge Ram 3500 Diesel Dually
daveinaz is offline   Reply With Quote