Quote:
Originally Posted by JoeUSNRET
I had a complete wet-bolt kit installed this spring and had 2 grease zerks that would not take grease. I used a 6 or 8mm wrench to loosen the zerk's and they both then took grease. then re-tighten the zerk, Maybe, give this a try as a simply fix. hope it helps.
|
Thanks, Joe. I'll give that a try first. I did try jacking up the wheels off the ground and even put a floor jack under each axle and slightly raised the axle to see if I could get grease in, but no joy. My rig isn't quite a year old yet, but I did the bearings early since I'm travelling a lot from September through the end of the year. And I read several posts where people found no grease in the bearings from the factory. Wanted to have some peace of mind knowing there was grease in there.