Quote:
Originally Posted by rohrmann
In 2016, I had developed a leak in the grey tank that I was able to repair with PlastiMend. Once this was done, I decided to add braces in addition to the two already installed. Since the bottom of the tanks are sloped, I added blocks of varying thicknesses, glued them to the bottom of the tanks where the braces would be located, reinstalled the coroplast and then reinstalled the braces. Don't have a worries about the two tanks failing, even if full.
|
Bob,
Did you look into using some sort of metal strapping with a threaded end on one or both ends ? I am thinking of straps we see holding on LPG tanks on forklifts, or even the old-fashioned straps holding gas tanks in cars. I was thinking they might be easier to have follow any tank contours and also being able to anchor them closer to the neutral center of the chassis beams. Just curious.