Quote:
Originally Posted by mhs4771
If you can get access to the backside of the WH, look for a small junction box with both 12V and 120V wires. Inside the box is a relay, the 12V controls the relay which then connects the 120V to the WH. There have been problems with loose wire nuts in that box.
|
Yes, that's going to be my next check I'll do, thank you for mentioning it because I was thinking something along those lines. I can access that area, it will require taking the panel off the backside but it's in my basement so it should not be a problem to get to it.
If anyone has a similar setup, I have a ton of storage underneath and it WAS all open until today, I've been installing "paneling" to close off the separate compartments which were just open with the aluminum bracing. To me, it gives the basement a more "finished" look and you don't lose any storage. And since I'm doing this project, removing the panels enclosing the WH shouldn't be a problem. Again, a BIG THANKS!