1retired06 can probably post a picture.
It isn’t much to them a T shaped piece of steel about .4 long with two 10 32 tapped holes and a 1 3/4 long piece of steel with three 10 32 holes and a 1/4 20 taped hole in the end to hold the cable adjuster. Both ends are 5/8 round steel with a through hole for the cable to go through. They are simple, you just need a machine shop to make them and that is why I made them. Not everyone has a machine shop especially the full timers. Kinda heavy with out being overweight.
Lynwood
|