|
The manual override on about any Montana product is the same after you open the described solenoid with the set screw ... using a 1/4" allen bit in your drill, insert it into the end of the slide/landing gear motor (there will be a little cover plate that you simply remove or punch thru) Clockwise makes the slides go in and counterclockwise makes the slides go out. Be sure and close the solenoid after you finish doing which ever direction. It takes a goodly charged drill motor to make this work if your slides are all the way out and it takes some patience due to slow speed. Also ... it sure wouldn't hurt if in your spare time you do look thru the manual as there is a lot of useful info other than what you are currently seeking.
|