Thread: Hello!
View Single Post
Old 04-11-2006, 03:53 AM   #10
VanMan
Montana Master
 
VanMan's Avatar
 
Join Date: Nov 2002
Location: Weatherford
Posts: 1,383
M.O.C. #9
Before an antenna is put down, there are a couple of arrows that need to be lined up. My guess is that the antenna was put down after installation without these being in line. They are molded into the plastic rings where the crank is. The arrows are supposed to be lined up so the antenna is in the correct position before cranking it down. If these are not lined up, then the antenna may indeed be hitting the A/C (or something else). If they are not in line, try pulling the outside ring down and rotating it (the shortest diection) to line it up with the other one. Don't be too forceful, though !! If it allows you to rotate it a little, then try raising it. Also be sure you are turning the crank in the correct direction - I know that sounds stupid but that's probably what I would be doing and not even realizing it.
VanMan is offline   Reply With Quote