[bcrvman]

Originally Posted by Bad Moon

Too bad Keystone cheaped-out and used the darco stuff where it didn’t show, rather than the better (more expensive) stuff they put under the bedroom slide, where it DOES show. I am leary of using screws to attach anything to the bottom of the slide, since screws will almost always eventually work loose, and rip up the vinyl floor covering. Is there an adhesive that would adhere to the product recommended above? Gorilla glue? Isocynate?

One of the attributes of UHMW plastic is almost nothing sticks to it. Just countersink the screws. My 2018 Montana has UHMW rub bars installed at the factory and they are screwed down. I check them occasionally to make sure the heads of the screws are not backing out.