I am installing something else right now, but should cut it today. The flat adapter is great, I did that also. I screwed it to the back of the dryer so it won't move, screw the Two pieces of the vent pipe together as well, then tape the connection with that Aluminum tape, (Lowe's)
I will measure both outside and inside, start the hole saw from the inside, cut into the wall until the pilot drill appears outside, then go out and finish the drilling. You can borrow or rent the 4" hole saw.
'07 3400RL 2nd RTU
2 Golf Cart batteries 3,000 watt inverter, automatic transfer switch
Honda 2000 Generator, Maytag's with 220 Dryer
Stationary domed Sat. dish, LCD 12 Volt Amp gauge, LCD Tank Monitor
3 added 120 volt outlets, On Board Air; 12 Volt Viair 450C compressor
2006 Ford PSD 4x4 Off Road Lariat, Hadley Air Horns, Truck inverter with 110 volts: laptop, Color Backup camera, Firestone air bags,Husky air ride roller hitch, Awning lock
