|
I'm not certain of your issue here, but the bottom tube with the holes in it just slides up inside the upper tube and is held in place by the pin with the bail wire on it that you use to adjust the amount of extension ... (some of us have a spring loaded shot pin). While hooked to your truck, if you are sitting on ground with a dip under the front landing gear legs, it is possible for the inner tube with the foot on it to drop out completely if you pull the pin and extend it down too far. Is your truck a 4WD that sits rather high?
On Edit ... what John said ... after re reading your post, it is looking toward the middle section being what you're talking about.
|