This has been one of my concerns too, so I'm planning to make a slip cover for the chair backs that is big enough to go over both, but has a divider in the middle that's a foam pad in a cloth casing (kind of like a pillow). It might need foam on the portion against the window and slides too, but not sure yet until I get the trailer (which is somewhere between the factory and the dealer). Sounds like if there are better straps, I should look into that too.
When it arrives I'll get a prototype built and adjust the length and tightness from there I think. Being a weekender, I'm also concerned about the setup time and would have rather had another couch in there as the setup time is much less.
|