[MandK]

Update on this thread. I installed the X factors on the equalizers and the rear hangers. Install on the rear hangers were easy and installing the X factor did partially pull the hangers straight. The propane pipe just cleared on the rear but I had to remove about 1/8” with the angle grinder from the top of the x factor on the center one, just the way it was, no big deal.
Also pulled the drums to check the bearings. My dealer must have greased them because the spindle cavity was full the way you would expect it to be when greasing using the ez lube. The seals were good, none were leaking. I had new seals so I hand packed them and now I don’t have to wonder about them anymore. The X factors help support the Coroplast sag too The front hangers are in line with the drain pipe for the kitchen gray tank, I think the “drop” X factor would work on that but didn’t install that one for now.