[RipNC]

Randy,
Just got my brackets and they are not going to work w/o substantial modification(s). I just sent photos to Lippert for follow up. There is an issue with vertcal clearance and the holes that are supposed to fit over/around the nubs of the 2 wear guides are not properly spaced (they are about 1" centers vs my actual wear guides which are about 1-3/4" centers).

The concept is to jack your slide arm to remove the weight on the gear pack, pull the outside GP bolt and Insert it thru the assembly as you re-bolt the gear pack - then crank the heavy plate down to remove the "crown" from the top of the inner arm (which holds the gear pack).

Photos attached for those that want to see the part and issues. Note the assembly is sitting on the inner arm and is too tall to go back on top of the outer arm where it needs to be installed.