Forum: Montana Problems, Problem Solving & Technical Help
11-07-2022, 01:27 PM
|
|
Replies: 12
Views: 3,321
|
|
Forum: New Member Introductions
03-05-2022, 12:05 PM
|
|
Replies: 14
Views: 2,421
|
|
Forum: General Discussions about our Montanas
08-19-2020, 02:19 PM
|
|
Replies: 29
Views: 11,417
9 hours is a long way to drive for warranty...
9 hours is a long way to drive for warranty issues. We had a long list of issues that were covered under warranty. I was lucky enough to be within 30 minutes of my dealer and didn't take it in until...
|
|
Forum: Montana Problems, Problem Solving & Technical Help
07-23-2020, 04:56 PM
|
|
Replies: 7
Views: 4,244
Rohrmann,
I do not have the pump on with...
Rohrmann,
I do not have the pump on with city water. The old pump would cycle for a second every couple of minutes, but after adding the check valve like you recommended it would just click every...
|
|
Forum: Montana Problems, Problem Solving & Technical Help
07-23-2020, 04:51 PM
|
|
Replies: 7
Views: 4,244
Thanks, I got the new valve with instructions...
Thanks, I got the new valve with instructions which mentioned being able to adjust it. With the new valve it neither cycles nor clicks nor overflows the fresh tank. All is well and I now have a spare...
|
|
Forum: General Discussions about our Montanas
07-09-2020, 03:01 PM
|
|
Replies: 48
Views: 10,511
|
|
Forum: Montana Problems, Problem Solving & Technical Help
07-02-2020, 12:46 PM
|
|
Replies: 7
Views: 4,244
Bob,
I had the same issue and added the...
Bob,
I had the same issue and added the check valve to prevent overflow while waiting on replacement pump, but now the pump clicks about every second or two. I don't need the pump with city...
|
|
Forum: Tow Vehicles & Towing
07-24-2019, 08:44 AM
|
|
Replies: 57
Views: 9,071
scale
the evidence...
Chevy 3500 LB DRW
2017 3791RD
steer 4880
drive 3700
trailer 0
|
|
Forum: Tow Vehicles & Towing
07-23-2019, 03:29 PM
|
|
Replies: 57
Views: 9,071
I think I may have stumbled upon your...
I think I may have stumbled upon your concern...the point load is behind the drive axle thereby 'lightening' the steering axle. 1) I believe the hitch does distribute some of the load in front of the...
|
|
Forum: Tow Vehicles & Towing
07-23-2019, 09:58 AM
|
|
Replies: 57
Views: 9,071
and there is no moment applied anywhere in the...
and there is no moment applied anywhere in the opposite direction to counter it.[/QUOTE]
if that were true you would obviously and quickly have a failure; the fact that it sets there and does not...
|
|
Forum: Tow Vehicles & Towing
07-23-2019, 09:54 AM
|
|
Replies: 57
Views: 9,071
|
|
Forum: General Discussions about our Montanas
08-24-2018, 08:13 AM
|
|
Replies: 23
Views: 5,501
Our roof material (TPO) is made by Dicor which...
Our roof material (TPO) is made by Dicor which recommends you clean and condition it twice a year with their roof cleaner and spot clean areas that need repair or touch-up with denatured alcohol.
...
|
|
Forum: Repairs & Service
08-13-2018, 09:44 AM
|
|
Replies: 31
Views: 5,406
Montana Man-
There are no slide adjusters...
Montana Man-
There are no slide adjusters or wear bar on this slide. The moisture barrier of the underbelly rides on that cheap plastic 'wear strip' up until the point where it rips the 'wear...
|
|
Forum: Repairs & Service
08-13-2018, 09:34 AM
|
|
Replies: 31
Views: 5,406
Bad Moon-
I used 1/4" UHMW scrap from a...
Bad Moon-
I used 1/4" UHMW scrap from a local plastics company. It was 14" wide scrap so I just cut it to length. I figured the wider the better.
On my 3791RD there is no way to clean under the...
|
|
Forum: Repairs & Service
08-13-2018, 09:25 AM
|
|
Replies: 31
Views: 5,406
Wade-
The slide had started to abrade the...
Wade-
The slide had started to abrade the kitchen floor where the damage on the underbelly was.
After removing the poorly secured, cheap, plastic 'wear strip' and attempting to bring in the...
|
|
Forum: Repairs & Service
08-03-2018, 12:12 PM
|
|
Replies: 31
Views: 5,406
I wondered if it is an adjustment issue, but it...
I wondered if it is an adjustment issue, but it seems that regardless of how high the slide is adjusted upwards on the two arms it will always bear weight on the 'wear bar'. But it might more evenly...
|
|
Forum: Repairs & Service
08-03-2018, 07:34 AM
|
|
Replies: 31
Views: 5,406
UPDATE 2:
there are no rollers or wear...
UPDATE 2:
there are no rollers or wear strips other than the black piece poorly installed with staples which twisted its way out of position at the first sign of resistance.
Temporary wear...
|
|
Forum: Repairs & Service
08-01-2018, 11:23 AM
|
|
Replies: 31
Views: 5,406
|
|
Forum: Repairs & Service
08-01-2018, 07:44 AM
|
|
Replies: 31
Views: 5,406
UPDATE:
Things deteriorated quickly...
...
UPDATE:
Things deteriorated quickly...
In my quest to discover and repair I ran the slide in a bit to raise it and peak in there to no avail. I'm at a campsite with limited tools and resources....
|
|
Forum: Repairs & Service
07-30-2018, 02:34 PM
|
|
Replies: 31
Views: 5,406
Kitchen slide damage
Howdy MOCers!
I'm hoping someone can help me find out what is causing the damage to the underbelly of my kitchen slide (2017 3791RD).
I have searched this Forum and find no similar issues.
I...
|
|
Forum: Repairs & Service
06-12-2018, 06:55 AM
|
|
Replies: 4
Views: 1,061
|
|
Forum: Repairs & Service
06-11-2018, 11:24 AM
|
|
Replies: 4
Views: 1,061
Roof repair
2017 3791RD
just noticed I have separation of roof at transition strip as shown in picture.
any advice on how best to repair this will be greatly appreciated!
|
|
Forum: Maintenance
04-13-2018, 11:13 AM
|
|
Replies: 5
Views: 1,450
|
|
Forum: New Member Introductions
04-06-2018, 11:33 AM
|
|
Replies: 21
Views: 2,767
bill-d-c,
I just discovered a local and...
bill-d-c,
I just discovered a local and mobile RV service guy out of Whitewater...Faron Schroeders Ready to Roll RV Service at 316-737-0657.
Just today came out to Harvey Co East Lake to repair...
|
|
Forum: New Member Introductions
04-06-2018, 08:12 AM
|
|
Replies: 21
Views: 2,767
HELLO from Newton KS and welcome aboard...
...
HELLO from Newton KS and welcome aboard...
Sorry to hijack the thread but I could use some tech help in regards to my Atwood furnace blowing soot. I suspect I have a nest in there somewhere but...
|
