Go Back   Montana Owners Club - Keystone Montana 5th Wheel Forum > Search Forums
Click Here to Login

Showing results 1 to 25 of 33
Search took 0.01 seconds.
Search: Posts Made By: lkennerly
Forum: Montana Problems, Problem Solving & Technical Help 03-18-2020, 01:01 PM
Replies: 45
Views: 2,227
Posted By lkennerly
Keystone marked where to put the vent CW failed...

Keystone marked where to put the vent CW failed to put it there!
Forum: Montana Problems, Problem Solving & Technical Help 03-17-2020, 07:35 AM
Replies: 45
Views: 2,227
Posted By lkennerly
There was a sticker at the upper part of the wall...

There was a sticker at the upper part of the wall and CW choose to ignore it. They also ignored our instructions to install on a shelf mounted as high as possible instead putting it on the closet...
Forum: Montana Problems, Problem Solving & Technical Help 03-17-2020, 06:08 AM
Replies: 45
Views: 2,227
Posted By lkennerly
Thanks for the confirmation of the patch. My...

Thanks for the confirmation of the patch. My husband is a structural engineer and he said the patch could work, but we are afraid the cut is too close to the floor. The patch design may have to be...
Forum: Montana Problems, Problem Solving & Technical Help 03-16-2020, 03:42 PM
Replies: 45
Views: 2,227
Posted By lkennerly
Wall Stud Cut by Camping World

We took our 2017 3160RL Montana to Camping World to install our Spendide Vented Dryer. (We did not want a washer.) We know we could install it ourselves, but we were afraid to try to cut the 4"...
Forum: General Discussions about our Montanas 02-27-2020, 08:54 AM
Replies: 26
Views: 2,038
Posted By lkennerly
I think I ordered it through Discount RV in...

I think I ordered it through Discount RV in Ringold, VA. it is where we purchased our Montana so they ordered the correct part.
Forum: General Discussions about our Montanas 02-26-2020, 01:20 PM
Replies: 26
Views: 2,038
Posted By lkennerly
Ours stripped out and the replacement was a...

Ours stripped out and the replacement was a better design. We replaced and it has worked great!
Forum: General Discussions about our Montanas 02-24-2020, 06:55 AM
Replies: 10
Views: 951
Posted By lkennerly
Both of our vent fans broke within a few days of...

Both of our vent fans broke within a few days of each other even though one was used twice as much. The "operator" part on both broke which caused it to act as if the gears were stripped. We...
Forum: General Discussions about our Montanas 02-13-2020, 08:43 AM
Replies: 6
Views: 235
Posted By lkennerly
Extended Warranty

We bought our 2017 3160RL new and we are starting our 3rd year. We didn't buy it from Camping World, but they offered an extensive extended warranty which would cover just about everything as long...
Forum: General Discussions about our Montanas 12-09-2019, 09:50 AM
Replies: 27
Views: 2,006
Posted By lkennerly
We live 45 minutes south so never camped in our...

We live 45 minutes south so never camped in our immediate area. However, the Greensboro, NC KOA is supposed to have decent ratings.
Forum: General Discussions about our Montanas 11-18-2019, 07:31 AM
Replies: 27
Views: 2,006
Posted By lkennerly
New Montana from VA

We purchased our Montana from the same dealer and they are great to work with. Some unusual items we encountered that are not on most check list.
- Mattress quilt stitching was "unquilting"
-...
Forum: Navigation 11-13-2019, 01:52 PM
Replies: 13
Views: 1,211
Posted By lkennerly
Garmin GPS

We used the Garmin on our second trip. Everything worked great until about 20 minutes from our destination we were directed on a road that was not fit for any towed vehicle. We had some cutbacks...
Forum: General Discussions about our Montanas 08-19-2019, 08:55 AM
Replies: 30
Views: 3,058
Posted By lkennerly
Tank Monitor

Do you recommend a brand for a good tank monitor?
Forum: General Discussions about our Montanas 07-04-2019, 01:10 PM
Replies: 14
Views: 1,167
Posted By lkennerly
Same thing happened to us. We use channel locks...

Same thing happened to us. We use channel locks until we fixed it. On ours the shank didnít have a flat spot for the set screw. We covered the bed then used a grinder to score a flat spot for the set...
Forum: Repairs & Service 07-01-2019, 06:39 AM
Replies: 5
Views: 559
Posted By lkennerly
Outside veneer/wall Screws Popped Out Pictures

When we had a better light we discovered to original screws had never penetrated the metal frame. The self-drilling screws would not penetrate so we drilled holes and were able to get the right side...
Forum: Repairs & Service 06-28-2019, 03:39 PM
Replies: 5
Views: 559
Posted By lkennerly
Outside Veneer/wall screws popped out

I just noticed that the first picture needs to be rotated clockwise so the screw tip points up and the second picture is upside down. I used a piece of foam so sunlight would not distort the image.
Forum: Repairs & Service 06-28-2019, 03:35 PM
Replies: 5
Views: 559
Posted By lkennerly
Outside veneer/wall Screws Popped Out Pictures

These pictures are looking forward from under the nose. One picture is from the left outside of the hitch, two are looking through the hitch one to the left and the other to the right side, and one...
Forum: Repairs & Service 06-27-2019, 09:25 AM
Replies: 5
Views: 559
Posted By lkennerly
Outside veneer/wall Screws Popped Out

The screws holding the outside shell/wall have become loose from the frame directly above our hitch under the nose. We are left with about a 1" gap exposing the inside area between the inside wall...
Forum: Additions & Improvements 06-12-2019, 06:12 AM
Replies: 5
Views: 602
Posted By lkennerly
I am not an electrician, so let me confirm. I...

I am not an electrician, so let me confirm. I will add a positive off the battery insert a fuse into it, then connect to the Blue Sea block. When you say a fuse large enough to cover the expected...
Forum: Additions & Improvements 06-11-2019, 07:02 AM
Replies: 5
Views: 602
Posted By lkennerly
Fuse Box for Distribution Panel

I want to install a Blue Sea 6 circuit fuse panel in our 3160RL front compartment. I can't find a recent post discussing how to do it. I am currently adding a TST repeater and a light and hope to...
Forum: Campgrounds 05-13-2019, 07:35 AM
Replies: 17
Views: 1,582
Posted By lkennerly
Pigeon Forge Campgrounds

The Ridge RV Resort is brand new and supposed to be very nice like Anchors Down, however we have never visited. I think it has the same owners as River Plantation RV Resort.
Forum: Montana Problems, Problem Solving & Technical Help 05-02-2019, 09:32 AM
Replies: 17
Views: 1,010
Posted By lkennerly
Trailer Brake Warning

We had similar warnings while moving. We have about 16,000 miles on our 3160RL and during axle service a worn wire was discovered inside one axle. They replaced the wires running them on the...
Forum: Maintenance 03-31-2019, 02:01 PM
Replies: 19
Views: 1,666
Posted By lkennerly
Mouse Entrance Areas

Maybe we were just lucky; our mouse problem stopped when we started keeping our slides closed when not in use.
Forum: Montana Problems, Problem Solving & Technical Help 02-04-2019, 09:45 AM
Replies: 7
Views: 604
Posted By lkennerly
Smile Hey, you need to sell that story!

Hey, you need to sell that story!
Forum: Montana Problems, Problem Solving & Technical Help 01-28-2019, 05:48 AM
Replies: 28
Views: 2,045
Posted By lkennerly
Great Pictures!! Very helpful!

Great Pictures!! Very helpful!
Forum: General Discussions about our Montanas 01-08-2019, 07:07 AM
Replies: 64
Views: 4,279
Posted By lkennerly
Sorry I meant 12v 50amp. It is the same as I...

Sorry I meant 12v 50amp. It is the same as I removed. When I searched 12v 80amp they looked completely different from what I removed.
Showing results 1 to 25 of 33

 
Forum Jump
Disclaimer:

This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 06:17 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
×