Forum: General Discussions about our Montanas
12-10-2008, 11:18 AM
|
|
Replies: 11
Views: 1,053
|
|
Forum: Montana Problems, Problem Solving & Technical Help
12-01-2007, 12:17 AM
|
|
Replies: 16
Views: 1,172
Dowman,
A few questions. Does this occure...
Dowman,
A few questions. Does this occure when you first press the wall switch? Is it it a clicking or more of a chattering sound? Does it sound like it is coming from under the bed or more...
|
|
Forum: Maintenance
06-27-2007, 02:06 PM
|
|
Replies: 17
Views: 1,573
Hi Gang,
I've told everyone and have done it...
Hi Gang,
I've told everyone and have done it myself, to use the silicone.
After you wash your coach, use a clean towel and dampen it with the silicone and simply wipe each side of the wiper...
|
|
Forum: Montana Problems, Problem Solving & Technical Help
06-27-2007, 01:56 PM
|
|
Replies: 9
Views: 3,118
dieselguy, you 'da man!!
Vanman, the "pusher...
dieselguy, you 'da man!!
Vanman, the "pusher bolts" that are mentioned are those two bolts, one at the end of each arm just behind the skirting that points straight down to the ground. Loosen the...
|
|
Forum: Maintenance
06-06-2007, 01:42 PM
|
|
Replies: 22
Views: 2,500
|
|
Forum: Tow Vehicles & Towing
06-06-2007, 01:38 PM
|
|
Replies: 35
Views: 2,438
Ozzie,
When you get that new truck and hook...
Ozzie,
When you get that new truck and hook up to the Mountaineer for the first time. Try pulling it in the normal mode. I'll bet you'll find out the truck will pull that thing with out much of a...
|
|
Forum: General Discussions about our Montanas
04-08-2007, 01:28 AM
|
|
Replies: 14
Views: 1,715
Oruion,
I had the same thing happen to me. ...
Oruion,
I had the same thing happen to me. My coach is equipped with 6K AL-KO axles. One of the bearing dust caps kept coming off. I would use a rubber mallet to snap it back in place but, it...
|
|
Forum: Maintenance
04-07-2007, 01:25 AM
|
|
Replies: 12
Views: 1,364
|
|
Forum: Montana Problems, Problem Solving & Technical Help
04-05-2007, 02:11 PM
|
|
Replies: 22
Views: 1,471
NO guys, the room bar is the square steel tube...
NO guys, the room bar is the square steel tube under the floor of the room just in behind the skirting. The lag bolts go up thru it into the floor of the room. At each end of the room bar is where...
|
|
Forum: Montana Problems, Problem Solving & Technical Help
04-04-2007, 12:56 PM
|
|
Replies: 22
Views: 1,471
Hey guys, that kitchen slide is slightly...
Hey guys, that kitchen slide is slightly different for a flush floor system than the other two main floor rooms in our units. That system, because the way the kitchen slide is built, is more flush...
|
|
Forum: Montana Problems, Problem Solving & Technical Help
04-03-2007, 01:36 PM
|
|
Replies: 8
Views: 1,868
PJ,
Those bolts you are talking about are...
PJ,
Those bolts you are talking about are for the 1" square cross shaft that extends from one gear pack assembly to the other. The dimensions of those are 1/4-20X2" zinc coated grade 8 bolts. ...
|
|
Forum: General Discussions about our Montanas
04-02-2007, 01:05 PM
|
|
Replies: 16
Views: 1,353
|
|
Forum: General Discussions about our Montanas
03-19-2007, 12:28 PM
|
|
Replies: 3
Views: 929
Bill,
Glenn, once again is correct! The two...
Bill,
Glenn, once again is correct! The two grey water tanks on our Challenger 35RLQ is 38 gallons each. The black tank, I think is right at 40 and the fresh water tank is 66 gallons.
|
|
Forum: Montana Problems, Problem Solving & Technical Help
02-11-2007, 02:48 AM
|
|
Replies: 5
Views: 3,955
bunker,
If you have an '06 3400RL, the slide...
bunker,
If you have an '06 3400RL, the slide rooms on your coach are hydraulically operated. The motor that turns the pump is operated with 12 volt power. Ideally, to move your slide rooms, a...
|
|
Forum: Maintenance
02-08-2007, 12:05 PM
|
|
Replies: 38
Views: 4,137
Gentlemen,
The motor that operates that pump...
Gentlemen,
The motor that operates that pump is rated to draw as much as 100 amps. Now, Keystone thinks that pump motor only draws 30 amps. That was according to a test they done a long time ago...
|
|
Forum: Montana Problems, Problem Solving & Technical Help
02-05-2007, 10:08 PM
|
|
Replies: 19
Views: 1,929
Dean,
When you get to RV Traders, you look...
Dean,
When you get to RV Traders, you look up the service manager by the name of Neldon. Tell him that Dale said he was suppose to treat you right. If he doesn't tell him he will be hunted down!...
|
|
Forum: General Discussions about our Montanas
02-05-2007, 11:36 AM
|
|
Replies: 33
Views: 2,937
I truly am thankful that no one was seriously...
I truly am thankful that no one was seriously hurt. But, that Lippert bed slide system kept the bed in place, didn't it?
That almost looks like the road conditions I endured with the Challenger...
|
|
Forum: Tow Vehicles & Towing
02-03-2007, 12:31 AM
|
|
Replies: 12
Views: 2,302
|
|
Forum: General Discussions about our Montanas
01-27-2007, 09:09 AM
|
|
Replies: 25
Views: 1,769
Gentlemen,
Depending on the model of Montana...
Gentlemen,
Depending on the model of Montana and weight ratings, your unit will have an 1116 or a 1621 model pin box made by Lippert. Most are 1621's.
However, now is about as good a time as...
|
|
Forum: Montana Problems, Problem Solving & Technical Help
01-22-2007, 01:32 PM
|
|
Replies: 16
Views: 2,790
Hi y'all,
That motor that drives the pump is...
Hi y'all,
That motor that drives the pump is rated to pull as much as 100 amps. That is why it has 6 gage wire feeding it from the battery. You know, larger hose, more water. Larger wire, more...
|
|
Forum: Montana Problems, Problem Solving & Technical Help
01-17-2007, 12:29 PM
|
|
Replies: 10
Views: 1,578
|
|
Forum: Montana Problems, Problem Solving & Technical Help
01-16-2007, 12:52 PM
|
|
Replies: 6
Views: 813
Yupper, Charlie. I'm still hangin' around! ...
Yupper, Charlie. I'm still hangin' around! Watching what is being written.
Tom, you brought up a very good point that I almost forgot about.
sgf, one of the things you may want to check is...
|
|
Forum: Montana Problems, Problem Solving & Technical Help
01-15-2007, 11:49 AM
|
|
Replies: 6
Views: 813
sfg,
When you suck the rooms back in again...
sfg,
When you suck the rooms back in again close all of the IRC valves except the one for the main room. If, over time while in storage, the main room creeps back out a little like the bed slide...
|
|
Forum: Tow Vehicles & Towing
01-12-2007, 01:24 PM
|
|
Replies: 30
Views: 2,861
|
|
Forum: General Discussions about our Montanas
01-08-2007, 11:23 AM
|
|
Replies: 13
Views: 3,588
|
