Bath motion sensor light
 

I did a search and didn’t find any info on this topic. We have a 2019 3931FB. Last night the master bath motion light started turning on/off by itself. Doing a search I found many posts about the stair lights and maybe the diode in those units are bad. Since the bath unit it a combination light/vent, I’m hoping someone else has come across this problem and has a solution.

We were connected via the shoreline 50amp connection. However, since the light is a 12 VDC system, I’m not sure this applies.

i have a 2020 3931fb i dont have a motion in the master bath which one of the light is motion? main light and then the vanity lights
al meyer
2020 3931 fb
az

Attachment 10418

It’s above the toilet. Here’s a picture of it.

High charging voltage will make that light crazy. I was messing with my charge settings on the inverter/charger I installed and the charge voltage went to 15v and the stair l8ght wigged out.

well i went out and looked as far as i can tell i do not have a motion in the main bath i have the same switch i believe. which light does it work?
al meyer
3931fb
az

It operates the light in the vent. It will be a LED around the ceiling vent.