jann

Hey Jack
All of the cables run to the key tv junction in the wet bay. Remove the screws on the key tv panel and pull it out and try tightening the connections. Good luck.

Hi Jack, The block that I needed to replace was the stationary one that holds the cable end. The cable was pulling through the block from being over torqued I suppose. The threaded block that travels on the threaded rod was fine. I bought two spares, one of each, when I bought the block I needed as they are fairly inexpensive so as long as I needed to pay freight, might as well get extras because some here have reported needing to replace the threaded block.
My unit was new when I replaced it so it’s been 3 years, iirc, lower the tire, remove the throughbolt that holds the block and install the cable end in the new block. I did not replace the threaded block, but I thought that you just continue to turn the crank counter clockwise until the threaded block is off the end of the screw.