Rear Den Model Question

[milsutter]

We wall betweena 3790RD & the partion between the kitchen &rear den has come loose. It is held into the wall by 3 screws. When I try to tighten the screws they do not tighten. Any suggestions?

[BuilderBob]

Try putting them in a different spot. The problem is at the factory they put them in with a impact gun & over tighten them see if you can a wall stud or even some of that backing that is supposed to be in the wall!

Bob & Carol
Washington St
2017 352RL 2008 Dodge 3500 DRW CC LB 4x4 6.7L

[speedster100]

Remember to pre-drill a small hole before relocating..... I added several additional screws along with PL200 adhesive and I also added a strip on the inside (theatre chair side) from top to bottom in the corner and another along the floor all with new screws to the wall and PL200. Better than new and don't expect any further issues, if I do I will add an additional corner piece on the kitchen side stained to the same colour. Don't think it will be necessary as the PL200 and new screws will likely hold fine. Also check the screws in the cabinets below on the kitchen side as they also hold the wall, couple of those were loose which I relocate and added too as well. Couldn't get the adhesive in behind on those ones though.

[milsutter]

Thanks for the ideas. I did not think of adding adhesive to it.