Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 

Go Back   Montana Owners Club - Keystone Montana 5th Wheel Forum > GENERAL DISCUSSIONS > General Discussions about our Montanas
Click Here to Login

Reply
 
Thread Tools Search this Thread Display Modes
 
Old 12-19-2012, 08:59 AM   #1
Larry-P
Montana Fan
 
Join Date: Jul 2011
Location: Elgin
Posts: 262
M.O.C. #11570
MAXIMUM WATER PRESSURE

We have a 2011 3455SA model Monty. I also have a Watson adjustable water pressure gage connected to the city water line. The gage is set at 50 lbs.

Does anyone know what the maximum pressure I can adjust the gage to and stay within the factory limits and not blow out a pipie or water connection?? It seems we have low water pressure at times and I would like to increase the pressure to 60 or 65 lbs.

Would this be within the safe limits of the Keystone requirements??
Thanks for your help.

Larry P
 
Larry-P is offline   Reply With Quote
Old 12-19-2012, 09:16 AM   #2
bncinwv
Montana Master
 
Join Date: Feb 2007
Location: Winfield
Posts: 7,327
M.O.C. #6846
My understanding is that the lines are rated at 120 psi. This does not mean however that the connections put together by the hard-working, quality-control conscience-minded workforce are rated at the same pressure. We have run ours at 60 psi with no problems, but if you increase the pressure, I would advise a quick occasional check to make sure there is no leakage anywhere. I do not believe you will blow out a pipe, the connections, however are a different story!! Keep in mind that if you have low pressure at the campground, you will not raise the pressure by adjusting your gage. In low pressure situations, we have resorted to filling the on-board fresh water tank and using the pump for our water needs.
Bingo
__________________

Bingo and Cathy - Our adventures begin in the hills of WV. We are blessed by our 2014 3850FL Big Sky (previous 2011 3750FL and 2007 3400RL) that we pull with a 2007 Chevy Silverado Classic DRW CC dually.
bncinwv is offline   Reply With Quote
Old 12-19-2012, 09:17 AM   #3
pineranch
Montana Master
 
Join Date: Oct 2009
Location: Navarre
Posts: 1,527
M.O.C. #9765
I believe 50-60 should give you all the pressure you will ever need. Much more and you will be living on the edge of needing a shop vac. If you see 50 on your gauge and still have low pressure inside, blockage may be the cause and you will need to isolate the problem and fix it, not increase outside pressure.
Mike
pineranch is offline   Reply With Quote
Old 12-19-2012, 09:22 AM   #4
dieselguy
Montana Master
 
dieselguy's Avatar
 
Join Date: Feb 2005
Location: Haysville
Posts: 4,261
M.O.C. #3085
Increasing the regulator pressure will not make low water pressure greater. If you're in a sutuation with low pressure depending on usage you're kinda stuck. That being said ... I've seen scores of people hooked directly to the water spigot without issue. I would offer your regulator has low flow characteristics, but you indicated you're using a Watson which generally has pretty good flow. You might examine your water source for issues.
dieselguy is offline   Reply With Quote
Old 12-19-2012, 09:54 AM   #5
Jolu
Montana Master
 
Join Date: Nov 2007
Location: Canon City
Posts: 1,340
M.O.C. #7919
I have my regulator set at 65 lbs. That is what works for us and have had no problems. However that pressure probably will put a test to any weak link in the system. If the pressure is higher than 65 lbs my pressure will be limited to 65 lbs. If it is lower pressure than the set 65 lbs I will have less pressure. It is a mixed bag from hookup to hookup as to what the pressure will be. We also have had to resort to the pump for more pressure at a couple of parks.
Joe
Jolu is offline   Reply With Quote
Old 12-19-2012, 11:45 AM   #6
kerry
Montana Master
 
Join Date: Apr 2007
Location: Frostproof
Posts: 512
M.O.C. #7125
I use an adjustable pressure regulator set at 60-65#. Works great and have had no issues.
kerry is offline   Reply With Quote
Old 12-19-2012, 12:14 PM   #7
Recumbent
Montana Master
 
Join Date: May 2010
Location: Rock Island
Posts: 1,074
M.O.C. #10457
Have our adjustable water pressure regulator set at 58 lbs. When we are at low pressure campgrounds we just go in slow motion, and it reminds us to not come back to that CG in future. We have noticed that CGs with an on site wellwater system seem to have the lowest water pressure.
Recumbent is offline   Reply With Quote
Old 12-19-2012, 12:40 PM   #8
Mudchief
Montana Master
 
Join Date: Nov 2005
Location: Paola
Posts: 5,739
M.O.C. #4961
I have ours set at 65 and have not had a problem.
__________________
Dennis & Linda Ward
Paola, Kansas
Montana 3735MK Legacy Edition
1200 watts of Solar
Mudchief is offline   Reply With Quote
Old 12-19-2012, 01:01 PM   #9
RJI47
Montana Fan
 
Join Date: Jul 2006
Location: No. Attleboro
Posts: 338
M.O.C. #6002
Send a message via AIM to RJI47 Send a message via Yahoo to RJI47
What is the pressure at the water spigot? Generally the CG will post what the water pressrue is. Have you had problems in the past which let you to use a regulator? I haven't even used a regulator in years, and never had a problem. Now that I've put it in writing, I suppose I'll blow a line real soon.
RJI47 is offline   Reply With Quote
Old 12-19-2012, 01:35 PM   #10
kab449
Montana Master
 
Join Date: Oct 2011
Location: Lykens
Posts: 545
M.O.C. #11842
I have a watts adjustable regulator also. Most campgrounds after I set up and check the flow at the shower I go out and take it off as I really couldn't get a decent shower. It is set at 60. They control the pressure but also cut down on the flow. Generally if you open the spigot before attaching the regulator you can get a feeling for the pressure and flow.
I also shut off the water when leaving for any length of time.
kab449 is offline   Reply With Quote
Old 12-19-2012, 01:37 PM   #11
7.3Ford
Montana Master
 
7.3Ford's Avatar
 
Join Date: Oct 2009
Location: Indian Land
Posts: 1,142
M.O.C. #9808
For some reason I had 40 psi in my mind, so I looked it up in the Montana's Owner Manual and all it says is to use pressure regulator. You might want to look up Jim Fisher's post, where he put in a 2 gallon bladder tank, primarily to reduce the amount of time pump runs, but might also help with your pressure problems.

Here is a picture of my regulator filter assembly all parts were purchased at Lowe's, except stand.



__________________
2015 Montana 3611RL - 2020 RAM 3500 SRW 4X4
John Walker, Indian Land, SC
Blog https://RoVIngWalkers.blogspot.com/
7.3Ford is offline   Reply With Quote
Old 12-19-2012, 03:38 PM   #12
DQDick
Site Team
 
DQDick's Avatar
 
Join Date: Jun 2011
Location: Wilsey
Posts: 18,799
M.O.C. #11455
We set ours at 65 and if we have to insulate and heat the line then I use a stainless steel preset at 55. Doesn't make much difference either way, we are seldom in an area with water pressure over 65.
__________________
Dick, Joyce, Diego, Picatso and Gustav
2017 3720 RL, and 2013 HC 343RL
Pullrite Hitch, IS, Disk Brakes, 3rd AC, Winegard Traveler, Bathroom door mod, Dometic 320, couch for desk swap, replaced chairs, sun screens, added awnings, etc.
DQDick is offline   Reply With Quote
Old 12-19-2012, 04:53 PM   #13
steelpony5555
Montana Master
 
Join Date: Jan 2012
Location: Copperas Cove
Posts: 1,426
M.O.C. #12096
Has anyone ever ran into a campground where they had more then 65 lbs of pressure at the spigot? I have a regulator but most cases the pressure is not that great, and I've never run into excessive pressure. Now I usually turn on the water and see if it gushes or trickles and use the regulator only if it gushes lol.
steelpony5555 is offline   Reply With Quote
Old 12-20-2012, 12:47 AM   #14
ols1932
Montana Master
 
Join Date: Aug 2004
Location: Cedar Rapids
Posts: 4,876
M.O.C. #1944
We run ours as high as 80 psi with no problems.

Orv
ols1932 is offline   Reply With Quote
Old 12-20-2012, 03:37 AM   #15
Jolu
Montana Master
 
Join Date: Nov 2007
Location: Canon City
Posts: 1,340
M.O.C. #7919
Yes, I have run into campgrounds with water pressure more than 65 lbs. A couple of times over time I have seen posted warnings the campgrounds pressure was over 100 lbs. Many times before I installed the regulator I ran into pressures 80 to 85 lbs. Before I installed the pressure regulator I always checked the pressure with a pressure gauge that I made up. With the regulator I only look at the gauge on the regulator when I hook up just to see what the pressure is. With a regulator it takes the guessing out.
Joe
Jolu is offline   Reply With Quote
Old 12-20-2012, 03:45 AM   #16
bncinwv
Montana Master
 
Join Date: Feb 2007
Location: Winfield
Posts: 7,327
M.O.C. #6846
Ditto Jolu, we have seen campground pressures of 100 psi on occasion as well. Regulator is another one of those cheap insurance purchases.
Bingo
bncinwv is offline   Reply With Quote
Old 12-20-2012, 03:46 AM   #17
8.1al
Montana Master
 
Join Date: Jun 2004
Location: Benson
Posts: 3,121
M.O.C. #1658
Quote:
quote:Originally posted by steelpony5555

Has anyone ever ran into a campground where they had more then 65 lbs of pressure at the spigot? I have a regulator but most cases the pressure is not that great, and I've never run into excessive pressure. Now I usually turn on the water and see if it gushes or trickles and use the regulator only if it gushes lol.
I also remove the regulator when the pressure is low as it restricts flow somewhat
8.1al is offline   Reply With Quote
Old 12-20-2012, 04:27 AM   #18
DQDick
Site Team
 
DQDick's Avatar
 
Join Date: Jun 2011
Location: Wilsey
Posts: 18,799
M.O.C. #11455
X3 on also having experienced a campground with high water pressure.
__________________
Dick, Joyce, Diego, Picatso and Gustav
2017 3720 RL, and 2013 HC 343RL
Pullrite Hitch, IS, Disk Brakes, 3rd AC, Winegard Traveler, Bathroom door mod, Dometic 320, couch for desk swap, replaced chairs, sun screens, added awnings, etc.
DQDick is offline   Reply With Quote
Old 12-20-2012, 05:00 AM   #19
helmick
Montana Master
 
Join Date: Oct 2008
Location: Siloam Springs
Posts: 2,206
M.O.C. #8890
We always use a pressure regulator, had a lot of parks well over 100lbs.
helmick is offline   Reply With Quote
Old 12-20-2012, 07:36 AM   #20
bigskyjimmy
Montana Master
 
Join Date: Aug 2010
Location: Washington Coast
Posts: 2,688
M.O.C. #10696
Just like JR147 said I have never had a problem in 2 years of fulltiming but now that i say that watch i will be posting that my pipes blew!
__________________
[
bigskyjimmy is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Maximum length for 50 amp? napria Montana Problems, Problem Solving & Technical Help 10 03-25-2015 06:14 AM
Water pressure low fluch toilet water press higher Dmax07 Montana Problems, Problem Solving & Technical Help 5 04-06-2014 03:48 AM
Low water pressure all around on city water JPConley General Discussions about our Montanas 11 07-25-2010 09:48 AM
No water pressure in city water system drylaarsdam Repairs & Service 8 03-31-2010 04:39 PM
$50.00 Maximum???????? Glenn and Lorraine Tow Vehicles & Towing 55 10-13-2006 07:07 AM

» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 01:45 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.