|
04-13-2013, 08:57 AM
|
#1
|
Established Member
Join Date: Oct 2012
Location: Pensacola
Posts: 15
M.O.C. #12920
|
Removing desk drawer in 3750FL
Some important papers fell out of one of the desk drawers into the bottom of the desk. Only way to get to them is to remove a drawer. Sounds simple but I can't figure out how to release the slides. Anybody know?
|
|
|
04-13-2013, 09:27 AM
|
#2
|
Montana Master
Join Date: Aug 2010
Location: Washington Coast
Posts: 2,688
M.O.C. #10696
|
Yep ,no problem when you pull the drawer all the way out look at the end of the slides and you will see little black "levers" that you have to push down on as you are pulling the drawer out ,push down on Both sides at the same time and then the whole drawer will come out, sometimes you have to wiggle them as you are pulling out but they will let loose
__________________
[
|
|
|
04-13-2013, 12:39 PM
|
#3
|
Montana Master
Join Date: May 2003
Location: New Bern
Posts: 4,294
M.O.C. #311
|
BigSkyJimmy is correct except on my drawers one lever pushes down and the opposite side lifts up. Left side up and Right side down.
Good luck.
|
|
|
04-13-2013, 01:33 PM
|
#4
|
Montana Master
Join Date: Nov 2003
Location: Santa Fe Springs
Posts: 4,189
M.O.C. #639
|
Quote:
quote:Originally posted by H. John Kohl
BigSkyJimmy is correct except on my drawers one lever pushes down and the opposite side lifts up. Left side up and Right side down.
Good luck.
|
Ditto that John.
__________________
Pulling a 2004, 2980 RL an oldie but goodie.
Tow vehicle is a 2009 RED RAM 3500 DRW.
|
|
|
04-13-2013, 02:24 PM
|
#5
|
Montana Master
Join Date: Aug 2010
Location: Washington Coast
Posts: 2,688
M.O.C. #10696
|
Yep corrected you are right guys left side push UP ,only looked at the right side, you know what they say "assumptions are the mother of all screwups"
__________________
[
|
|
|
04-13-2013, 02:26 PM
|
#6
|
Montana Master
Join Date: Oct 2011
Location: Lykens
Posts: 545
M.O.C. #11842
|
I found it helps if you use a flat blade screwdriver to pry the black lever and then slide the middle section toward the rear of the drawer working on one side at a time. Don't completely disconnect the sections of the drawers slide but move it enough so it stays disconnected until you can do the other side. Once both sides are disconnected then you can pull the drawer completely out. Some of the levers are very hard to move enough to disconnect.
Hope this helps.
|
|
|
04-14-2013, 04:16 AM
|
#7
|
Established Member
Join Date: Oct 2012
Location: Pensacola
Posts: 15
M.O.C. #12920
|
Thanks everyone. Papers retrieved. bigskyjimmys first recommendation had me thinking I was going nuts. Once I did the left up, right down it was a cinch.
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Disclaimer:
This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.
All times are GMT -6. The time now is 05:16 PM.