Graphics - 3400RL
Not sure if thuis has been posted before but I just received the instructions for the graphics installation for my 3400RL.Keystone is sending out shortly.
Exterior Graphic Installation / Removal Instructions
Below is a step by step guide to successful graphic removal
Soften graphic and adhesive by first warming the graphic with a heat gun or blow dryer. Facing graphic to the sun on a warm day will also help.
After removing graphic, any remaining adhesive can be removed by using chemical cleaners such as lacquer thinner or citrus cleaner.
Make sure to thoroughly clean residue left behind by these chemicals with isopropyl alcohol before applying a replacement graphic.
Below is a step by step guide to successful graphic installation
Surface temperature of substrate should be a minimum of 45 degrees for optimal adhesion and performance.
Clean substrate thoroughly with isopropyl alcohol prior to graphic application.
Use proper application tool to apply graphic; squeegee for smooth wall; rivet brush for corrugated metal.
Remove liner from back of graphic.
Gently place graphic in desired application location.
Squeegee vertically in center of graphic towards the outer edges. Graphics can be lifted to removed slack and prevent creases prior to squeegeeing, but not after.
Leave protective pre-mask on graphic for at least 15 minutes prior to removing.
Remove pre-mask by pulling 180 degrees across the graphic, not 90 degrees away from the substrate.
Graphic should be re-squeegeed after removal of pre-mask, especially where removal begins and at small points.
Air bubbles can be popped and removed by using a tool with a fine point, like a pin. Do not use a wide blade like a Stanley or exacto knife.
|