Go Back   Montana Owners Club - Keystone Montana 5th Wheel Forum > GENERAL DISCUSSIONS > General Discussions about our Montanas
Click Here to Login

Reply
 
Thread Tools Display Modes
 
Old 09-05-2010, 11:33 AM   #1
Roberts
Established Member
 
Join Date: Jan 2007
Location: Naperville
Posts: 13
M.O.C. #6727
Ford Built In Trailer Brake Control

We have a chronic problem indicating the trailer brakes are not working at times. The red light will bleep and beep when going over a bumpy road. Have had it looked at four times various places and no one seems to find the problem. Trailer was rewired once three years ago and we again have the same problem. Anyone have similar problem? Thanks
Roberts is offline   Reply With Quote
Old 09-05-2010, 12:00 PM   #2
bobsals
Montana Fan
 
Join Date: Mar 2010
Location: West Sand Lake
Posts: 267
M.O.C. #10232
Greetings, just something to try. I took an old bicycle inner tube and cut 1/2" rings out of it (like calamari) I took one of these rubber rings and put it over the cable then stretch it over the spring loaded recepticle cover to hold it tight against the plug. Have been doing this for years with no connection problem. Worth a try. Good Luck
bobsals is offline   Reply With Quote
Old 09-05-2010, 01:42 PM   #3
Bruce.B
Established Member
 
Join Date: Oct 2009
Location: Santa Fe
Posts: 19
M.O.C. #9794
Had a problem which sounds similar. In our case the trailer-disconnected message popped up and wouldn't go away. A mobile repair tech found there was a continuity problem with the connector in the bed of the truck, but there was no problem with the connector down by the hitch. His explanation was the the bed connector isn't OEM so it isn't part of the original Ford wiring. His theory (which proved to be right) was that there was probably a loose connection in one of the wires that were attached to the original wiring harness in order to connect the after market connector in the bed. So for the next many miles I just connected to the connector by the hitch till I could get the repair done.

If your problem is similar, just try moving to that original Ford-installed connector and see if things get better. If they do, then you (or someone) will have to 'get out and get under' to repair the flakey connection going to the connector in the bed. Odds are good that the installation wasn't done with solder so corrosion is likely what's causing a problem.
Bruce.B is offline   Reply With Quote
Old 09-05-2010, 02:14 PM   #4
Jdrobone
Montana Fan
 
Join Date: Oct 2009
Location: Wilsons
Posts: 401
M.O.C. #9833
Had an after-market receptacle wired into the bed of my F-350. There was no real wiring to be done. The harness "T" connected to the original harness at a joint near the rear end and then ran up to the new outlet, all connections were sealed so only inspection is to cut it apart - if it's loose the little guys in China didn't make the joints right.
Jerry
ps have had no problems with it as yet.
Jdrobone is offline   Reply With Quote
Old 09-08-2010, 07:11 AM   #5
jksimons
Established Member
 
Join Date: Sep 2009
Location: Vacaville
Posts: 48
M.O.C. #9659
Send a message via AIM to jksimons
Ford has a message in thier computers very nicely placing the blame on the trailers. I went through this problem many times, one more then one type of trailer, to the extreme of them blaming me for possibly soda spilling on the unit..um who were the idiots who put it right next to the drink holder? At this time I had it happening with my Logan horse trailer. Called Logan dealer and they said, nope, it's the brake controller. I sold the truck, but was close to just installing a normal brake controller and disconnecting the on board model. Nothing scarier then stopping with a trailer and the brakes going out from this issue..too close of call.
jksimons is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
2013 ford f250 built in brake control Happycamperscolorado Tow Vehicles & Towing 7 01-20-2015 12:35 PM
Integrated trailer brake control in the new truck hydman Tow Vehicles & Towing 17 08-20-2012 12:56 PM
Ford brake controller--"Trailer Fault" --THE FIX?? David and Jo-Anna Tow Vehicles & Towing 19 07-24-2009 03:29 PM
FORD with tow mode built in ,what # tow sailer Tow Vehicles & Towing 17 10-01-2007 03:19 AM
Ford built in brake controllers DCP Tow Vehicles & Towing 34 09-24-2006 02:15 PM

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Montana RV, Keystone RV Company or any of its affiliates. This is an independent, unofficial site.


All times are GMT -6. The time now is 12:49 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
×