|
09-20-2013, 09:03 AM
|
#1
|
Established Member
Join Date: Sep 2013
Location: Boise
Posts: 40
M.O.C. #13739
|
Propane/furnace-oven
Hi to all. I'm a new member and first time owner of a 2010 3400RL. We love the Montana and this fourm and hope someone can help with a propane issue. I have 2 full propane tanks, some time the furnace will work sometime not. When it doesn't neither will the stove, the burners will light for a couple min then dim and go out. We've switched back and forth between tanks but no change. Do you think this sounds like a bad regulator? Common problem? Thanks,Steve
|
|
|
09-20-2013, 10:14 AM
|
#2
|
Site Team
Join Date: Jun 2011
Location: Wilsey
Posts: 18,799
M.O.C. #11455
|
Does this happen only when you open the tanks for the first time or off and on after the tanks have been on for a while. If it's when the tanks are first opened it could be that you're opening them too fast. That causes a safety valve to close and very little or no propane will come out. If it's intermittent when the tanks have been open I'd check the regulator they have been known to be an issue.
__________________
Dick, Joyce, Diego, Picatso and Gustav
2017 3720 RL, and 2013 HC 343RL
Pullrite Hitch, IS, Disk Brakes, 3rd AC, Winegard Traveler, Bathroom door mod, Dometic 320, couch for desk swap, replaced chairs, sun screens, added awnings, etc.
|
|
|
09-20-2013, 10:16 AM
|
#3
|
Montana Master
Join Date: Oct 2009
Location: Navarre
Posts: 1,527
M.O.C. #9765
|
Since problem happens with either tank, common source is the automatic change over valve.
Mike
|
|
|
09-20-2013, 11:59 AM
|
#4
|
Established Member
Join Date: Mar 2010
Location: Gatesville
Posts: 14
M.O.C. #10236
|
Mine was doing that and I had 2 bad hoses. They have a check valve in them that fails.
|
|
|
09-20-2013, 01:44 PM
|
#5
|
Montana Master
Join Date: Oct 2004
Location: Salem
Posts: 7,550
M.O.C. #2283
|
I think you are turning the valves on too fast. Try turning them off then bump the tank around a bit and turn then back on a little bit very slowly after you have cut off every thing that uses propane let the line pressurize. Then cut the valves back on.
Lynwood
|
|
|
09-23-2013, 03:21 AM
|
#6
|
Montana Fan
Join Date: Apr 2013
Location: Lehigh Acres
Posts: 492
M.O.C. #13354
|
Since we are talking ovens. Recommendation: Get a 12 X 12 inch of Terra cotta tile and place in the over just above the flame/below the rack. It will help distribute the heat evenly when baking.
|
|
|
09-27-2013, 08:32 PM
|
#7
|
Established Member
Join Date: Sep 2013
Location: Boise
Posts: 40
M.O.C. #13739
|
Thanks for the input. Still trying to run this to ground but I didn't know the lines had check valves in line, I'll check those. Thanks again, Steve
|
|
|
09-28-2013, 02:21 AM
|
#8
|
Montana Master
Join Date: Feb 2012
Location: Lake Gaston
Posts: 8,773
M.O.C. #12156
|
When I had a similiar problem, (brand new unit), it turned out to be a kink in the propane line.
__________________
Mike and Lorraine
2002 3655 FL, 2005 3650RK
2010 3665RE, 2015 3910FB
F350 crew cab dually 6.7
|
|
|
09-28-2013, 02:32 AM
|
#9
|
Montana Master
Join Date: Mar 2013
Location: Hanover
Posts: 1,471
M.O.C. #13325
|
X2 on possibly turning the valves on too fast. I've several propane things (weed burner, fry burner, grill) that have 'safety' features where if you don't turn the valves on slowly, something in the line thinks you've a loose hose and mostly shuts off. Don't know why this doesn't completely shut off (if you've a major leak, why have even a little propane coming?), and it is what it irritatingly is. Also don't know when these started being installed to irritate people.
__________________
|
|
|
09-28-2013, 07:32 AM
|
#10
|
Established Member
Join Date: Sep 2013
Location: Boise
Posts: 40
M.O.C. #13739
|
Being a newbie, I hadn't turned the tanks off between trips /storage and this only happened on the last trip so shouldn't be the opening of the valves too quickly, I don't think but I'm open to trying anything. Getting cold here in Idaho so def. need a reliable furnace. Thanks
|
|
|
09-28-2013, 02:23 PM
|
#11
|
Montana Master
Join Date: Oct 2012
Location: Chilliwack
Posts: 1,520
M.O.C. #12935
|
I would assume that there is a small red regulator in the door side compartment on the pipe that crosses over to the main regulator/selector unless something has been modified. Sometimes the small regulator has been a problem, however in your case neither tank is supplying propane to the stove and furnace, so I would disregard this regulator. The output of the Main regulator is fed into a steel line that runs along the frame and up to the furnace and hot water heater then on to the stove.
Propane from either tank is fed into the Auto switching regulator via flexible hoses at the top of the regulator. A flexible line out of the bottom of the regulator feeds the main supply line. I would bet it is this regulator that is the problem. It would certainly not be the first time. There is the possibility the output hose is kinked enough to stop/reduce the flow to the appliances as it would be highly unlikely both flex hoses from the tanks would be likely to be kinked.
I am not sure I should/would recommend the following but this is what I would do. Turn off both tanks, remove the hose from the bottom of the regulator where it attaches to the main feed pipe and turn on a tank to see if you have propane coming out of the regulator. It should be very obvious and would only require the valve to be open momentarily.
You certainly must be very careful with this type of test and make sure there are no open flames anywhere near the area. Not the best way of doing things but would answer the question.
I am not a subscriber to the speed at which a propane tank is turned on, I have never paid the least attention to that and have never had a problem related to doing it one way as opposed to another.
When it starts getting chilly it is not a fun time to be trying to solve heat problems. Hope you can resolve it quickly.
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
Similar Threads
|
Thread |
Thread Starter |
Forum |
Replies |
Last Post |
propane furnace
|
patandjohn |
Additions & Improvements |
10 |
01-06-2015 12:24 PM |
Furnace/propane
|
Firstrmc |
General Discussions about our Montanas |
20 |
11-15-2013 10:11 AM |
Propane Furnace
|
PowellsMonty |
General Discussions about our Montanas |
12 |
04-14-2013 02:52 AM |
Propane Oven? Opinions, please.
|
Montana_6246 |
Full Timing in your Montana |
28 |
01-30-2007 09:51 AM |
Furnace / Propane
|
Montana_5701 |
Brrr it's cold outside! Winter Camping |
11 |
11-30-2006 03:50 PM |
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|