Range Vent Cover Replacement

[RKassl]

The range vent cover on the outside of the Monty has became a nasty yellow color. I would like to change it with a new one. Does the cover simply bolt on? Is there any internal connection to the vent duct itself to be concerned with?

Thanks.

[kerry]

Bob, you should be able to remove the screws and pry off the outside vent, might need a puddy knife to get started. Clean off the area, put some puddy tape on the new vent and screw it back on . Trim off the excess puddy tape after tighting, and seal around the new vent with a thin bead of white silicon. Should look like new. Kerry

[bigmurf]

Can of white spray paint has held up for 3 years now.

[greener]

Krylon plastic paint will make it look like a new one.

[snfexpress]

Acetone will make the yellowed plastic on our rigs white again. Be careful, though, as acetone (nail polish remover) dissolves most plastics so a little goes a long way. Put some on a rag and test an unobtrusive area, first. If you like what you see, go for it.

[Charlie]

Mine has started to turn yellow and my thoughts were Krylon paint but I think I'll try the acetone thing first.