Furrion Range/Oven

[Creeker]

The Furrion Range/Oven in our new 310RE is mounted unlevel.
Very unlevel. At least half an inch higher on one side than the other.
Of course, that's the one manual that wasn't included in our paper work.
We have 5 for the microwave though.

My question is does anyone know how they are mounted? Where are the
mounting screws? I only see two screws for the trim on the front of the unit. I'm fairly certain there are several main mounting screws somewhere on the inner part of the unit. I'm just not seeing them.

Yes, I know its a warranty issue but we purchased our unit 6 hours from home and our local Montana dealer is.... Well, I drove 6 hours to buy ours elsewhere for a reason. Besides that, I just don't want the hassle and down time of a dealer.

If anyone has the manual and could take a look for the mounting screws location I would very much appreciate it.
Its stainless steel, three burner, cast iron grates with folding glass cover.
Has the blue lights for the knobs and auto spark ignitor for the oven and cooktop. (Forgot to write down the model number)

[prndl]

Take your pick of Furrrion devices
https://www.furrion.com/support/manuals-downloads.html

[Creeker]

Thanks much for the link.
Found our range/oven and the mounting screws in the installation diagram.

Will definitely make things a little easier.

[Creeker]

Just a follow up;

The entire top of the range/oven was assembled wrong from the factory.
Under the grates is a one piece metal top with tabs that simply push and lock into the range frame. The incompetent/lazy employees simply wouldn't take the time to correctly line up the tabs to lock the top in place. They actually bent the tabs over with them just laying on top of the slots. One side of the range top was 3/4" of an inch off the counter top and the other side laying flat. (If that wasn't bad enough, they drove a sheet metal screw through the metal top to try and hold it in place). Since this metal top also holds the grates in place they were also 3/4" off level from side to side.

I removed grates, glass cover, their sheet metal screw which didn't belong and the metal top. Unfolded/straightened the metal tabs they bent over
and took the time to line all back up correctly. It slid right in place, all tabs locked, perfectly level with both sides of the flange laying flat on the counter.

Thanks again for the link prndl.