Landing Gear Repair
I searched and couldn't find my exact problem and didn't put this under repairs since that has to do with dearlers and I plan on doing this myself. As I get older and more absent-minded things just seem to happen. I was in a hurry, which usually causes these problems. After hitching up I raised the landing gear and started out of our driveway which is about 400' and uphill. When I got to the top I realized that I had not walked around to the door side to pull the pin and finish raising the landing gear on that side. It was too late and the damage was done. I couldn't go back down the drive without doing more damage and there is a hill on the way out that I knew it would scrape again and do more damage, so I was stuck in the road. The tube was just barely bent, but, it was enough where it wouldn't go up. I tried a sledge hammer and could not get it straight enough to work. I walked down to the house and got my floor jack to force the leg up inside of the other. In hindsight I think I would have been better off taking a reciprocating saw and cutting it off where maybe I could have just replaced the inner tube that slides manually. Anyway, I tell all of this on myself to ask if the two inner tubes can be replaced or do I need to get the whole assembly for that side? This was our last trip in November so I just used some blocks under that side and our 5er has been parked at home since. Thanks for any advice in advance.
|