|
When I mounted my camera, though my is hard wired. I guess determined were I needed to place the camera bracket and marked it. I use a drill bit that was just a little smaller than the screw. I put caulking on the screw as I was putting it in. The hole for the wire. The grommet that came with my system was already on the wire. The rear cap is to thick for the grommet to fit correctly, so I had to trim it so it would fit and caulked it fitting it in.
__________________
2006 Montana 3650RK with Improvements.
2014 Ford 6.7L PSD 4WD CC LB Dually & Hadley's.
|
Hybrid Mode
