Storage tube retrevial device, or getter outter

[Ozz]

When all, the hoses are way in my 8 foot tube, especially if I have some unused sections, I made a 'Puller outer' with some steel strap, angle iron and a 3/4" electrical box nut.
On the 6" tube for the ladder, I think I will screw some web straps to the ladder to pull it out. It's heavy and with just your fingertips, might be hard to remove. Sue has some webbing strap material, I'll make a loop and screw it to the ladder for a pull.
Hey Ozzie I figured out how to do the Tinypics deal with one motion, thanks to all that helped. Ozz, the computer master!!!!
Sorry about the sideways picture, maybe computer master in training.......
http://i8.tinypic.com/25jbkuq.jpg
http://i8.tinypic.com/25jblme.jpg


'07 3400RL 2nd RTU
2 Golf Cart batteries 3,000 watt inverter, automatic transfer switch
Honda 2000 Generator, Maytag's with 220 Dryer
Stationary domed Sat. dish, LCD 12 Volt Amp gauge, LCD Tank Monitor
3 added 120 volt outlets, On Board Air; 12 Volt Viair 450C compressor
2006 Ford PSD 4x4 Off Road Lariat, Hadley Air Horns, Truck inverter with 110 volts: laptop, Color Backup camera, Firestone air bags,Husky air ride roller hitch, Awning lock

[sreigle]

I used to use the awning rod as my puller outer. It worked well. But now I store the awning rod alongside the awning hardware to keep the roller from rolling off the fabric while on the road. That's a tip I picked up on this forum. So a separate, dedicated puller outer would be nice to have. I'll have to see if I can fabricate something like that.

See another Montana or Mountaineer on the road? Flash lights twice, it might be one of us!
Steve Reigle (pronounced Regal)
Fulltiming since 3/21/03
'03 3295RK
'05 Ford F250 SD Lariat CC SB 6.0L PSD/TS FX4 4x4

Our RV Travels (now Firefox-compatible)