floor under sink

[blarkman]

finally did the kitchen faucet repair. while under the sink I happened to notice that the floor was hanging low at back. A quick look confirmed that when they put the pressedboard down they put it below the support boards!!! I had a hard time removing it and ended up cutting it out as it would not bend enough. So I cut a new piece of 1/2plywood flooring and split it in the middle and put the expensive 1/2 supports under the board where it should have been. They must have made that section upside down as staples came up from bottom.
bob

[Longwell]

Weird.
Is it possible for "Old World Craftsmen" to come to work drunk?
Thanks for the tip on things to watch.
Larry

[NCFischers]

I went to a sheet metal guy and had a pan made to fit under the sink. If water ever starts to leak, it will wind up in the pan and not on the wooden cabinet floor. Then I went to Lowes and bought a moisture alarm and placed it in the pan.